The Sensors group in the web console contains every local sensor, input, output, and field-bus configuration page. Configure one channel at a time, save it, and verify the result on Overview before moving to the next channel.
Configuration workflow
Confirm the wiring
Isolate power before changing field wiring. Check terminal assignments, signal ranges, polarity, and the device datasheet.
Open the channel
Select its page from Sensors, choose the channel or device, and enable it.
Name and configure it
Use a name that identifies the measurement or controlled equipment. Configure units, scaling, publishing, or operating behavior as required.
Save and verify
Save the settings, return to Overview, and confirm that the value or state is correct. Review Diagnostics > Hardware if it is unavailable.
Choose a guide
Environment and analog
Configure enclosure conditions and four analog input channels.
Temperature and digital inputs
Configure NTC, PT100, contact-state, and pulse-counting inputs.
Outputs
Configure and test the relay and three digital outputs.
Modbus
Set up the RS-485 bus and define registers to poll.
Hardware status labels
| Status | Meaning |
|---|---|
| OK | The hardware is available. |
| Turned off | The channel is disabled in its configuration. |
| Not detected | The expected component was not found. |
| Could not start | Initialization failed. |
| Configuration failed | The saved settings could not be applied. |
| Stopped working | The component failed during operation. |
| Status unavailable | The console has not loaded a status yet. |
| Fault | The gateway reported a general hardware error. |
For recovery actions, see Firmware and diagnostics.